Caution / Notice / Hint

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Front bumper assembly	Front television camera view adjustment	Panoramic View Monitor System	for Initialization Refer to INITIALIZATION [06/2018 - 09/2022] for Calibration Refer to CALIBRATION [06/2018 - 09/2022]
Headlight ECU sub-assembly LH Headlight assembly LH	Synchronize the vehicle information Perform headlight ECU sub-assembly LH initialization*1	Lighting System	Refer to INITIALIZATION [08/2020 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]

*1: for LED Type Turn Signal Light