LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Engine Cooling System (A25A-FKS) - Service Information) >> FLOW SHUTTING VALVE (for ATF) >> Removal [08/2020 - 08/2021] >> Procedure

Removal [08/2020 - 08/2021]: Procedure

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE BATTERY 

    Refer to REMOVAL [08/2020 - 08/2021]

  2. REMOVE ECM 

    Refer to REMOVAL [08/2020 - 08/2021]

  3. REMOVE BATTERY CLAMP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  4. REMOVE FRONT WHEEL LH 

    Refer to PROCEDURE - Step 1

  5. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 8

  6. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 9

  7. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 10

  8. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 11

  9. REMOVE FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 12

  10. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 1

  11. REMOVE FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) 
    1. Disengage the 3 clamps to remove the transmission breather clamp.
      GTY771515Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 3 clamps to remove the hose clamp.
      GTY754106Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 2 clamps to disconnect the flow shutting valve (No. 1 water by-pass hose) and transmission breather hose from the hose clamp.
      GTY754107Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Slide the clip and disconnect the flow shutting valve (No. 1 water by-pass hose) from the water outlet.
      GTY772835Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use a container to catch any engine coolant which flows out of the flow shutting valve (No. 1 water by-pass hose) and water outlet.

    5. Slide the clip and disconnect the flow shutting valve (No. 1 water by-pass hose) from the transmission oil cooler.
      GTY760085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use a container to catch any engine coolant which flows out of the flow shutting valve (No. 1 water by-pass hose) and transmission oil cooler.

    6. Disconnect the flow shutting valve (No. 1 water by-pass hose) connector.
      GTY760088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Remove the bolt and flow shutting valve (No. 1 water by-pass hose).
      GTY754108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals