Vehicle Control History [10/2019 - 09/2022]
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.
- CHECK VEHICLE CONTROL HISTORY NOTE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.
Refer to PRECAUTION [10/2019 - 08/2021] , or refer to PRECAUTION [08/2021 - 09/2022]
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB).
Body Electrical > Telematics > Utility
Tester Display Vehicle Control History (RoB) VEHICLE CONTROL HISTORY ITEMCode Tester Display Description Diagnostic Note X2210 Life Cycle of DCM Backup Battery When the system detects that the mobilephone battery has reached the end of its lifespan. - The manual (SOS) switch red indicator illuminates
- Replace mobilephone battery
Refer to REMOVAL [10/2019 - 09/2022]
NOTE:- After replacing the mobilephone battery, perform initialization.
Refer to INITIALIZATION [10/2019 - ]
- After performing work, perform "CLEAR VEHICLE CONTROL HISTORY" to turn off the manual (SOS) switch red indicator.
X2211 Low DCM Backup Battery Charge When the mobilephone battery charge is low. - X2601 Software Inconsistency with ENG/HV Control Module The VIN number received via CAN communication does not match that stored in the DCM (telematics transceiver). - The manual (SOS) switch red indicator illuminates
- Perform VIN Synchronization
Refer to DCM ACTIVATION [10/2019 - ]
X2213 Emergency Call Switch Stuck On The manual (SOS) switch is on for 5 minutes or more - The manual (SOS) switch red indicator illuminates.
- Replace roof console box assembly
Refer to REMOVAL [06/2018 - ]
X2214 Communication Blackout from Power Distribution Controller ECU Lost Communication with ECM Check CAN Communication System
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]X2212 Diagnostics Communication Flow Failure Diagnostics communication flow failure(ID, Mode/SID difference). - X2215 Non Approval of the Reprograming User did not approve software update. - X2216 Failure of the Reprogramming Software writing failed. - X2217 Inconsistent Startup Software Software writing succeeded, but started software does not match package. -
- CLEAR VEHICLE CONTROL HISTORY NOTE:
By performing this procedure, all stored Vehicle Control History will be cleared.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB) (Clear).
Body Electrical > Telematics > Utility
Tester Display Vehicle Control History (RoB) - According to the display on the Techstream, clear the Vehicle Control History (RoB).