Wireless Charger Illumination Circuit [06/2018 - 09/2022]: Procedure
WARNING: This page is about a different car, the 2022 Lexus ES 300h, 2021 Lexus ES 300h, 2020 Lexus ES 300h, and 2019 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
- Disconnect the H8 mobile wireless charger cradle assembly connector.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition H8-10 (TAIL) - Body ground Taillight off Below 1 V Power switch off, taillight on 11 to 14 V Result
Proceed to OK NG
Result:
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [06/2018 - 09/2022]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR