Installation [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
1. Install the vacuum switching valve (for active control engine mount system) to the front engine mounting insulator with the nut.
  Torque: 6.0 N.m (61 kgf/cm, 53 in.lbf)
2. Connect the 3 vacuum hoses to the vacuum switching valve (for active control engine mount system).
3. Engage the wire harness clamp and connect the vacuum switching valve (for active control engine mount system) connector.
4. Install the wire harness clamp bracket to the transmission case side cover with the bolt.
  Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
5. Engage the 2 wire harness clamps and install the engine wire with the bolt.
  Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 46 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 47 [08/2021 - ]
INSTALL INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 47 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 48 [08/2021 - ]
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 48 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 49 [08/2021 - ]
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 2 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 2 [08/2021 - 09/2022] , or refer to PROCEDURE - Step 2 [09/2022 - ]