Removal [08/2021 - 09/2022]: Procedure
WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE STARTER ASSEMBLY
Refer to REMOVAL [08/2021 - 09/2022]
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the crankshaft position sensor connector.
- Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.NOTE:
If the crankshaft position sensor has been struck or dropped, replace it.
- Perform this procedure only when reusing the crankshaft position sensor.
*1 O-ring - Remove the O-ring from the crankshaft position sensor.NOTE:
- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
- If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.
- Remove the O-ring from the crankshaft position sensor.
- Disconnect the crankshaft position sensor connector.