LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Battery / Charging System (A25A-FXS) - Service Information) >> Battery Current Sensor >> Removal [09/2022 - ] >> Procedure

Removal [09/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE BATTERY STATE SENSOR ASSEMBLY 
    1. Turn back the luggage compartment trim cover RH as shown in the illustration.
      GTY818720Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Remove the nut and disconnect the No. 2 frame wire from the battery state sensor assembly.
      NOTE:

      When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.

      Refer to INITIALIZATION [09/2022 - ]

      GTY781420Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.
      GTY828655Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the battery state sensor assembly connector.
      GTY761262Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disengage the 2 claws to remove the battery state sensor assembly from the battery current sensor holder.
      GTY761260Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals