Customize Parameters [06/2018 - 09/2022]

WARNING: This page is about a different car, the 2022 Lexus ES 300h, 2021 Lexus ES 300h, 2020 Lexus ES 300h, and 2019 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

CUSTOMIZING WITH REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY)

Customizing with the touch function cancellation function. (w/ Touch Function Cancellation Function)

NOTE:

Confirm the touchpad surface is free of foreign matter before customizing.

Turn the power switch on (ACC).

Simultaneously press and hold the "MAP" switch and back switch for 5 seconds or more.

Fig 1: Locating "HOME" Switch And Back Switch

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	"MAP" Switch
*b	Back Switch

While pressing and holding the "MAP" switch and back switch, tap the touchpad with 2 fingers.

Fig 2: Pressing And Holding "Home" Switch And Back Switch, While Tapping Touchpad With 2 Fingers

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Example

HINT:

If any switch other than the "MAP" switch or back switch is pressed, the customize setting cannot be changed.
Do not pinch in/out or slide fingers when tapping the touchpad with 2 fingers.

Confirm that the answer-back function vibrates the touchpad a specified number of times to indicate that the setting has changed.

SETTING

Touch Function Cancellation Function	Number of Answer Back Vibrations
Off (Default)	1
On	2

Repeat step (3) until the desired setting is selected.
HINT:

The touch function cancellation function alternates between on and off.
Release the "MAP" switch and back switch to select the set value.