LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Smart Access System (For Start) (Hybrid) - Diagnostic Codes) >> SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Start Function, HV Model) >> DTC U0100: Lost Communication with ECM / PCM; DTC U0140: Lost Communication with Main Body ECU; DTC U0142: Lost Communication with Main Body ECU; DTC U0155: Lost Communication with Combination Meter; DTC U0293: Lost Communication with Hybrid Vehicle Control System [06/2018 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When using the Techstream with the power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

HINT: 

When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

scientia non olet · About LEMON Manuals