LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 175 (Engine Mechanical System (A25A-FXS) - Service Information (3 Of 3)) >> Cylinder Block >> Replacement [06/2018 - ] >> Procedure

Replacement [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REPLACE RING PIN 
    NOTE:

    It is not necessary to remove the ring pins unless they are being replaced.

    1. Remove the 12 ring pins.
    2. Using a plastic hammer, install 12 new ring pins.
      GTY758988Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Top Side *b Bottom Side
      *c Protrusion Height *d 14 mm (0.551 in.)
      *e 12 mm (0.472 in.) - -

      Standard Protrusion Height

      5.0 to 7.0 mm (0.197 to 0.276 in.)

  2. REPLACE STRAIGHT PIN 
    NOTE:

    It is not necessary to remove the straight pins unless they are being replaced.

    1. Remove the 10 straight pins.
    2. Using a plastic hammer, install 10 new straight pins.
      GTY764600Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front Side *b Rear Side
      *c LH Side *d Bottom Side
      *e RH Side *f Protrusion Height
      *g 22 mm (0.866 in.) *h 10 mm (0.394 in.)
      *i 14 mm (0.551 in.) *j 6.0 mm (0.236 in.)

      Standard Protrusion Height

      Straight Pin Specified Condition
      (A) 11.0 to 13.0 mm (0.433 to 0.512 in.)
      (B) 5.0 to 7.0 mm (0.197 to 0.276 in.)
scientia non olet · About LEMON Manuals