How To Proceed With Troubleshooting [06/2018 - ]: Procedure

Result

Result: 

NEXT 

See step  2

1. Measure the auxiliary battery voltage with the power switch off.

   Standard voltage

   11 to 14 V (Power switch off)

   If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Refer to DIAGNOSIS SYSTEM [06/2018 - 10/2019] , or refer to DIAGNOSIS SYSTEM [10/2019 - 08/2020] , or refer to DIAGNOSIS SYSTEM [08/2020 - 08/2021] , or refer to DIAGNOSIS SYSTEM [08/2021 - 09/2022] , or refer to DIAGNOSIS SYSTEM [09/2022 - ]

   Result

   Result	Proceed to
   CAN DTCs are not output.	A
   CAN DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ] 

Result: 

A 

See step  4

1. Check for DTCs.

   Body Electrical > Tilt&Telescopic > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2018 - 08/2021]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2021 - ]  

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [06/2018 - 08/2021] , or refer to PROBLEM SYMPTOMS TABLE [08/2021 - ] 

   Result

   Result	Proceed to
   Problem symptom does not occur.	A
   Problem symptom occurs.	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Terminals of ECU.

   Refer to TERMINALS OF ECU [06/2018 - 08/2020] , or refer to TERMINALS OF ECU [08/2020 - ] 

2. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [06/2018 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END