DTC P0011-00: Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1 [08/2020 - 08/2021]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0011-00)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0011-00 is output A DTC P0011-00 and other DTCs are output B HINT:
If any DTCs other than P0011-00 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2020 - 08/2021]
Result:
A
See step 2
- REPLACE CAMSHAFT TIMING GEAR ASSEMBLY
- Replace the camshaft timing gear assembly.
Refer to PROCEDURE - Step 30
HINT:
Perform "Inspection After Repair" after replacing the camshaft timing gear assembly.
Refer to INITIALIZATION [08/2020 - 08/2021]
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Replace the camshaft timing gear assembly.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Clear the DTCs.
HINT:
Clear the DTC without using the Techstream.
- Turn the power switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 4
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P0011-00 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [08/2020 - 08/2021]