LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Control System (A25A-FKS) - Diagnostic Codes (03 Of 12)) >> SFI System >> DTC P012F-62: Engine Coolant Temperature/Engine Oil Temperature Signal Compare Failure [08/2020 - 08/2021] >> Description

DTC P012F-62: Engine Coolant Temperature/Engine Oil Temperature Signal Compare Failure [08/2020 - 08/2021]: Description

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.

The engine is equipped with an engine coolant temperature sensor and an engine oil temperature sensor. The engine coolant temperature sensor and engine oil temperature sensor each have a built-in thermistor. As the temperature decreases, the thermistor resistance increases and as the temperature increases, the thermistor resistance decreases. The voltages at the respective terminals of the ECM change in accordance with the changes in the resistance of the thermistors. The ECM performs control based on these voltages.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P012F-62 Engine Coolant Temperature/Engine Oil Temperature Signal Compare Failure All of the following conditions are met (2 trip detection logic):
  1. The battery voltage is higher than 8 V.
  2. 5 hours or more have elapsed since the engine stopped on the previous trip.
  3. The engine oil temperature is -10°C (14°F) or higher.
  4. The engine coolant temperature is -10°C (14°F) or higher.
  5. The difference between the readings of the engine coolant temperature and engine oil temperature is higher than 20 °C (36 °F).
  • Engine coolant temperature sensor
  • Oil pressure and temperature sensor
  • ECM
Comes on DTC stored SAE Code: P012F