Installation [06/2018 - 10/2019]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL OIL PRESSURE SENSOR (OIL PRESSURE SENDER GAUGE ASSEMBLY)
- Apply adhesive to 2 or 3 threads of the oil pressure sensor (oil pressure sender gauge assembly).
Adhesive
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
*a Adhesive 1344 *b Oil Inlet Port NOTE:- Do not apply adhesive to the oil inlet port of the oil pressure sensor (oil pressure sender gauge assembly).
- Install the oil pressure sensor (oil pressure sender gauge assembly) within 3 minutes of applying adhesive.
- Using a 27 mm deep socket wrench, install the oil pressure sensor (oil pressure sender gauge assembly) to the cylinder block sub-assembly.
Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)
- Connect the oil pressure sensor (oil pressure sender gauge assembly) connector.
- Apply adhesive to 2 or 3 threads of the oil pressure sensor (oil pressure sender gauge assembly).
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6
- INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 42
- INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 43
- INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 44
- INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 45