Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE OIL LEVEL SENSOR
1. Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.
  Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
2. Install a new clip to the engine oil level sensor.
3. Connect the engine oil level sensor connector.
INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Refer to PROCEDURE - Step 12 [06/2018 - 07/2019] , or refer to PROCEDURE - Step 12 [07/2019 - 10/2019] , or refer to PROCEDURE - Step 12 [10/2019 - 08/2021] , or refer to PROCEDURE - Step 12 [08/2021 - ]
ADD ENGINE OIL
Refer to PROCEDURE - Step 5 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 5 [08/2021 - ]
INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 6 [08/2021 - ]
CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [06/2018 - 07/2023] , or refer to PROCEDURE - Step 1 [07/2023 - ]
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 42 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 43 [08/2021 - ]
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 43 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 44 [08/2021 - ]
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 44 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 45 [08/2021 - ]
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 45 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 46 [08/2021 - ]