Caution / Notice / Hint

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Front bumper assembly	Front television camera view adjustment	Panoramic View Monitor System	Refer to CALIBRATION [09/2022 - ]
Headlight ECU sub-assembly LH Headlight assembly LH*1	Synchronize the vehicle information Perform headlight ECU sub-assembly LH initialization*2	Lighting system	Refer to INITIALIZATION [08/2021 - ]
Radiator shutter assembly	Change grille shutter control mode and/or perform initialization	Grille Shutter system	Refer to INITIALIZATION [08/2021 - ]

*1: for Bulb Type Turn Signal Light

*2: for LED Type Turn Signal Light