LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Engine Cooling System (A25A-FXS) - Service Information) >> Radiator >> Removal [06/2018 - 08/2021] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly Front television camera view adjustment Panoramic View Monitor System for Initialization
Refer to INITIALIZATION [06/2018 - 09/2022]
for Calibration
Refer to CALIBRATION [06/2018 - 09/2022]
Headlight ECU sub-assembly LH
  • Synchronize the vehicle information
  • Perform headlight ECU sub-assembly LH initialization (for LED Type Turn Signal Light)
 Lighting system Refer to INITIALIZATION [06/2018 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021]
  • Swing grill actuator assembly
  • Radiator shutter sub-assembly
 Change grille shutter control mode and/or perform initialization Grille Shutter system Refer to INITIALIZATION [06/2018 - 08/2021]
scientia non olet · About LEMON Manuals