When Voice Recognition Switch is Pressed a Short Beep is Emitted but the Voice Recognition System does not Start [09/2022 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 300h, 2024 Lexus ES 250, 2023 Lexus ES 350, and 2023 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONDITION
- While paying attention to the condition of the spoken voice command, perform a voice recognition operation.
HINT:
- When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Cancel" is spoken, "Cancel" is displayed in the voice recognition result display area.)
- If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
- The system cannot recognize voice commands when multiple people are speaking simultaneously.
- If the speaking speed is too fast or too slow, the recognition rate may decrease.
- The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
OK
Voice command is recognized normally.
Result
Proceed to OK NG
Result:
OK
END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION)
Result:
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [09/2022 - ]
- While paying attention to the condition of the spoken voice command, perform a voice recognition operation.