LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Audio / Video System (For 8 Inch Display) - Diagnostic Codes (1 Of 2)) >> AUDIO AND VISUAL SYSTEM (for 8 Inch Display) >> DTC B1579-13: Voice Recognition Microphone1 Circuit Open [09/2022 - ] >> Procedure

DTC B1579-13: Voice Recognition Microphone1 Circuit Open [09/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 300h, 2024 Lexus ES 250, 2023 Lexus ES 350, and 2023 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK HARNESS AND CONNECTOR (TELEPHONE MICROPHONE ASSEMBLY LH - RADIO RECEIVER ASSEMBLY, DCM (TELEMATICS TRANSCEIVER)) 
    1. Disconnect the P24 telephone microphone assembly LH connector.
    2. Disconnect the G147 radio receiver assembly connector.
    3. Disconnect the G128 telematics transceiver connector.
    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      P24-5 (SNS1) - G147-25 (SNS) Always Below 1 Ω
      P24-4 (MO1-) - G128-7 (MCI-) Always Below 1 Ω
      P24-5 (SNS1) or G147-25 (SNS) - Body ground Always 10 kΩ or higher
      P24-4 (MO1-) or G128-7 (MCI-) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  2

  2. INSPECT DCM (TELEMATICS TRANSCEIVER (MCI-)) (MCI-) 
    1. With the telematics transceiver connectors connected, disconnect the P24 telephone microphone assembly LH connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      P24-4 (MO1-) - Body ground Always Below 1 Ω

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE DCM (TELEMATICS TRANSCEIVER). Refer to  REMOVAL [09/2022 - ] 

    Result: 

    OK 

    See step  3

  3. INSPECT TELEPHONE MICROPHONE ASSEMBLY LH (SNS2, MO1-) 
    1. Remove the telephone microphone assembly LH.
      GTY1068090Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Telephone microphone assembly LH)
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      5 (SNS1) - 4 (MO1-) Always Below 1 Ω

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to  REMOVAL [09/2022 - ] 

    Result: 

    NG 

    REPLACE TELEPHONE MICROPHONE ASSEMBLY LH. Refer to  REMOVAL [09/2022 - ]