DTC P0010-01: Camshaft Position "A" Actuator Bank 1 General Electrical Failure [08/2021 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT CAMSHAFT TIMING GEAR ASSEMBLY
*1 Camshaft Timing Gear Assembly *2 Eccentric Shaft *a Spline - Remove the cam timing control motor with EDU assembly.
Refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
- Check if the eccentric shaft of the camshaft timing gear assembly rotates smoothly.NOTE:
If the camshaft is at a position where a valve is about to open, the eccentric shaft may become difficult to rotate.
OK
Rotates smoothly.
HINT:
Perform "Inspection After Repair" after replacing the camshaft timing gear assembly, or removing or replacing the cam timing control motor with EDU assembly.
Refer to INITIALIZATION [08/2020 - ]
Result
Proceed to OK NG
Result:
OK
REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY. Refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
Result:
NG
REPLACE CAMSHAFT TIMING GEAR ASSEMBLY. Refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
- Remove the cam timing control motor with EDU assembly.