Wireless Charger Illumination Circuit [06/2018 - 09/2022]: Procedure

1. Disconnect the H8 mobile wireless charger cradle assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   H8-10 (TAIL) - Body ground	Taillight off	Below 1 V
   	Engine switch off, taillight on	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2018 - 09/2022]  

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR