Removal [09/2022 - ]: Procedure

Refer to REMOVAL [09/2022 - ]

Refer to PROCEDURE - Step 1

HINT: 

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 3

1. Release the lock lever and disconnect the connector from the brake actuator assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Release the lock lever
   	Disconnect the connector

   NOTE:

   Be careful not to allow any brake fluid to enter the connector.

2. Use tags or make a memo to identify the places to reconnect the brake lines.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	From 1st Chamber of Brake Booster with Master Cylinder Assembly
   *b	From 2nd Chamber of Brake Booster with Master Cylinder Assembly
   *c	To Front Wheel Cylinder Assembly RH
   *d	To Rear Wheel Cylinder Assembly LH
   *e	To Rear Wheel Cylinder Assembly RH
   *f	To Front Wheel Cylinder Assembly LH

3. Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Do not kink or damage the brake lines.
   • Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
4. Apply protective tape to the vehicle body as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Protective Tape

5. Remove the 2 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Insert the tool from the bottom of the vehicle.

6. Remove the nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

7. Remove the brake actuator with bracket as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Do not kink or damage the brake lines.
   • Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
   • Be careful not to allow any brake fluid to enter the connector.
   • Do not hold the brake actuator assembly by the connector.
   • Do not drop the brake actuator with bracket when carrying it.

   HINT: 

   Remove the brake actuator with bracket while avoiding the brake lines.

1. Remove the 3 bolts and brake actuator assembly from the brake actuator bracket assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Do not hold the brake actuator assembly by the connector.
   • Do not drop the brake actuator assembly when carrying it.

1. Remove the 3 brake actuator case collars from the brake actuator bolt cushions.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Brake Actuator Case Collar
   *2	Brake Actuator Bolt Cushion

2. Remove the 3 brake actuator bolt cushions from the brake actuator bracket assembly.