Data List / Active Test [06/2018 - 08/2021]
- DATA LIST NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Head Up Display / Data List.
- Read the Data List according to the display on the Techstream.
Body Electrical > Head Up Display > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Total Distance Traveled Total driving distance Min.: 0, Max.: 16777215 Current total driving distance - Total Distance Traveled - Unit Total driving distance unit km or mile Current total driving distance unit - Main Switch Headup display switch (No. 2 combination switch assembly) OFF or ON OFF: Headup display off
ON: Headup display on- +B Voltage Battery voltage Min.: 0.0 V, Max.: 25.5 V or Unset 11 to 14 V - Illumination Rate from Illuminance Sensor Light control sensor input value Min.: 0 lx, Max.: 65535 lx or Unset Value according to the brightness is output 0 is displayed when there is no light Vehicle Speed Meter Vehicle speed input value (Brake ECU) Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) or Unset Almost the same as actual vehicle speed - Engine RPM Engine speed Min.: 0 rpm, Max.: 12701 rpm or Unset Almost the same as actual tachometer - Brightness Up Switch Brightness up switch OFF or ON OFF: Switch released
ON: Switch pushedThis item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. Brightness Down Switch Brightness down switch OFF or ON OFF: Switch released
ON: Switch pushedThis item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. Projection Position Up Switch Projection position up switch OFF or ON OFF: Switch released
ON: Switch pushedThis item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. Projection Position Down Switch Projection position down switch OFF or ON OFF: Switch released
ON: Switch pushedThis item can be inspected by adjusting a setting in the HUD settings of the settings tab displayed on the multi-information display. Display Change Switch Headup display switch (CAN communication line) OFF or ON OFF: Headup display off
ON: Headup display onNot applicable to this vehicle Display Angle Headup display angle Min.: -12.7 deg, Max.: 12.8 deg or Unset Actual headup display angle - Approximately -12.7 deg: Displays at lowermost position
- Approximately 12.8 deg: Displays at uppermost position
Ambient Temperature (Celsius) Outside temperature (Celsius) Min.: -40.0°C, Max.: 87.1°C or Unset Almost the same as actual outside temperature - Ambient Temperature (Fahrenheit) Outside temperature (Fahrenheit) Min.: -40°F, Max.: 215°F or Unset Almost the same as actual outside temperature - Illumination Rate from Light Control Sensor Light control sensor input value Min.: 0 lx, Max.: 65535 lx or Unset Value according to the brightness is output - LDA System Existence of lane control system Without or With Without: w/o Lane Control System
With: w/ Lane Control System- PCS System Existence of pre-collision system Without or With Without: w/o Pre-collision System
With: w/ Pre-collision System- ICS System Existence of parking support brake system Without or With Without: w/o Parking Support Brake System
With: w/ Parking Support Brake System- Radar Cruise System Existence of dynamic radar cruise control system Without or With Without: w/o Dynamic Radar Cruise Control System
With: w/ Dynamic Radar Cruise Control System- Intuitive P/A System Existence of parking support alert system Without or With Without: w/o Parking Support Alert System
With: w/ Parking Support Alert System- Road Sign Assist System Existence of road sign assist system Without or With Without: w/o Road Sign Assist System
With: w/ Road Sign Assist System- ITS System Existence of ITS connect Without or With Without: w/o ITS Connect
With: w/ ITS Connect- HV System Indicator Hybrid system indicator value Min.: -101%, Max.: 511% or Unset Current hybrid system indicator value Not applicable to this vehicle Navigation System Existence of navigation system Without or With Without: w/o Navigation System
With: w/ Navigation System- Audio Information Display Function Setting of audio system operation status display OFF or ON OFF: Audio system operation status display not displayed
ON: Audio system operation status display displayedNot applicable to this vehicle Master Caution Display Function Setting of master warning light OFF or ON OFF: Master warning light not displayed
ON: Master warning light displayedDisplays customize setting of Master Warning Light Function Speed Limit Display Function Setting of speed limit display OFF or ON OFF: Speed limit display not displayed
ON: Speed limit display displayedDisplays customize setting of Speed Limit Display Function Turn by Turn Animation Function Setting of route guidance to destination display OFF or ON OFF: Route guidance to destination display not displayed
ON: Route guidance to destination display displayedNot applicable to this vehicle Traffic Sign Recognition Animation Function Setting of traffic sign recognition display OFF or ON OFF: Traffic sign recognition display not displayed
ON: Traffic sign recognition display displayedNot applicable to this vehicle Memory Call Link Function Setting of headup display memory call link function OFF or ON OFF: Memory call link function off
ON: Memory call link function onDisplays customize setting of Memory Call Link Function Seat Switch Link Function Setting of headup display power seat switch link function OFF or ON OFF: Power seat switch link function off
ON: Power seat switch link function onDisplays customize setting of Power Seat Switch Link Function ECO Drive Indicator Zone Display Function Setting of ECO driving indicator zone OFF or ON OFF: Eco driving indicator zone not displayed
ON: Eco driving indicator zone displayedDisplays customize setting of ECO Driving Indicator Zone Display Function Pedestrian Alert System Existence of pedestrian reminder system Without or With Without: w/o Pedestrian Reminder System
With: w/ Pedestrian Reminder System- FCTA System Existence of front cross traffic alert system Without or With Without: w/o Front Cross Traffic Alert System
With: w/ Front Cross Traffic Alert System- LTC System Existence of lane tracing control system Without or With Without: w/o Lane Tracing Control System
With: w/ Lane Tracing Control System- LCS System Existence of lane change assist system Without or With Without: w/o Lane Change Assist System
With: w/ Lane Change Assist System- LVN System Existence of traffic movement notification system Without or With Without: w/o Traffic Movement Notification System
With: w/ Traffic Movement Notification System- Driver Emergency Stop Assist System Existence of driver emergency stop assist system Without or With Without: w/o Driver Emergency Stop Assist System
With: w/ Driver Emergency Stop Assist System- HINT:
Depending on the specifications of the vehicle, some items may not be displayed.
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Head Up Display / Active Test.
- Perform the Active Test according the display on the Techstream.
Body Electrical > Head Up Display > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Color Test Screen (Black) Headup display (Black color) ON - Color Test Screen (White) Headup display (White color) ON - Color Test Screen (Red) Headup display (Red color) ON - Color Test Screen (Green) Headup display (Green color) ON - Color Test Screen (Blue) Headup display (Blue color) ON - Color Test Screen (Color Bars) Headup display (Color bars) ON - Color Test Screen (Adjustment) Headup display (Adjustment screen) ON - Display Brightness Headup display (Display brightness) 0 to 100% - Display Position Headup display (Display position) Up (+3), Up (+2), Up (+1), Center, Down (-1), Down (-2) or Down (-3) - HINT:
Depending on the specifications of the vehicle, some items may not be displayed.