LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> RX 450hL >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (2 Of 2) >> Back Door >> Adjustment [10/2015 - 03/2018] >> Procedure

Adjustment [10/2015 - 03/2018]: Procedure

  1. INSPECT BACK DOOR 
    1. Check that the clearance measurements of areas a through g are within each standard range.
      GTY615509Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      STANDARD CLEARANCE

      Area Measurement Area Measurement
      a 5.95 to 9.95 mm (0.234 to 0.392 in.) b -1.15 to 2.85 mm (-0.0453 to 0.112 in.)
      c 5.95 to 9.95 mm (0.234 to 0.392 in.) d -1.15 to 2.85 mm (-0.0453 to 0.112 in.)
      e 3.15 to 7.15 mm (0.124 to 0.281 in.) f 3.85 to 6.85 mm (0.152 to 0.270 in.)
      g 4.55 to 8.55 mm (0.179 to 0.337 in.) - -
  2. REMOVE TONNEAU COVER ASSEMBLY 

    Refer to PROCEDURE - Step 1 [10/2015 - 08/2016] , or refer to PROCEDURE - Step 1 [08/2016 - 12/2017] , or refer to PROCEDURE - Step 1 [12/2017 - 08/2019]

  3. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 2 [10/2015 - 08/2016] , or refer to PROCEDURE - Step 2 [08/2016 - 12/2017] , or refer to PROCEDURE - Step 2 [12/2017 - 08/2019]

  4. REMOVE REAR NO. 3 FLOOR BOARD 

    Refer to PROCEDURE - Step 3 [10/2015 - 08/2016] , or refer to PROCEDURE - Step 3 [08/2016 - 12/2017] , or refer to PROCEDURE - Step 3 [12/2017 - 08/2019]

  5. REMOVE REAR DECK FLOOR BOX 

    Refer to PROCEDURE - Step 4 [10/2015 - 08/2016] , or refer to PROCEDURE - Step 4 [08/2016 - 12/2017] , or refer to PROCEDURE - Step 4 [12/2017 - 08/2019]

  6. REMOVE REAR NO. 4 FLOOR BOARD 

    Refer to PROCEDURE - Step 5 [10/2015 - 08/2016] , or refer to PROCEDURE - Step 5 [08/2016 - 12/2017] , or refer to PROCEDURE - Step 5 [12/2017 - 08/2019]

  7. REMOVE FRONT DECK FLOOR BOX 

    Refer to PROCEDURE - Step 6 [10/2015 - 08/2016] , or refer to PROCEDURE - Step 6 [08/2016 - 12/2017] , or refer to PROCEDURE - Step 6 [12/2017 - 08/2019]

  8. REMOVE DECK SIDE TRIM BOX RH 

    Refer to PROCEDURE - Step 7 [10/2015 - 08/2016] , or refer to PROCEDURE - Step 7 [08/2016 - 12/2017] , or refer to PROCEDURE - Step 7 [12/2017 - 08/2019]

  9. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 8 [10/2015 - 08/2016] , or refer to PROCEDURE - Step 8 [08/2016 - 12/2017] , or refer to PROCEDURE - Step 8 [12/2017 - 08/2019]

  10. ADJUST BACK DOOR 
    1. Before adjusting the upper end of the back door up and down or left and right, loosen the 4 bolts.
      GTY639014Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Tighten the body side hinge after adjustment.

      Torque: 19.5 N*m (199 kgf*cm, 14 ft.*lbf) 

    3. Using a T40 "TORX" socket wrench, slightly loosen the striker mounting 2 screws.
      GTY639136Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Using a brass bar and a hammer, hit the striker to adjust its position.
    5. Using a T40 "TORX" socket wrench, tighten the striker mounting 2 screws after adjustment.

      Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf) 

  11. INSTALL REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 50 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 49 [12/2017 - ]

  12. INSTALL DECK SIDE TRIM BOX RH 

    Refer to PROCEDURE - Step 51 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 50 [12/2017 - ]

  13. INSTALL FRONT DECK FLOOR BOX 

    Refer to PROCEDURE - Step 52 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 51 [12/2017 - ]

  14. INSTALL REAR NO. 4 FLOOR BOARD 

    Refer to PROCEDURE - Step 53 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 52 [12/2017 - ]

  15. INSTALL REAR DECK FLOOR BOX 

    Refer to PROCEDURE - Step 54 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 53 [12/2017 - ]

  16. INSTALL REAR NO. 3 FLOOR BOARD 

    Refer to PROCEDURE - Step 55 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 54 [12/2017 - ]

  17. INSTALL DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 56 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 55 [12/2017 - ]

  18. INSTALL TONNEAU COVER ASSEMBLY 

    Refer to PROCEDURE - Step 57 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 56 [12/2017 - ]

scientia non olet · About LEMON Manuals