LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> RX 450h Base >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System (Service Information) >> FUEL PUMP ECU(w/o Rear No. 2 Seat) >> Installation [10/2015 - ] >> Procedure

Installation [10/2015 - ]: Procedure

  1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY 
    1. Install the fuel pump control ECU assembly to the vehicle body and return the deck trim side panel assembly LH to its original position.
    2. Install the 2 nuts.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    3. Install the clip.
    4. Connect the 2 fuel pump control ECU assembly connectors.
  2. INSTALL FRONT DECK FLOOR BOX 

    Refer to PROCEDURE - Step 52 , or refer to PROCEDURE - Step 51

  3. INSTALL REAR NO. 4 FLOOR BOARD 

    Refer to PROCEDURE - Step 53 , or refer to PROCEDURE - Step 52

  4. INSTALL REAR DECK FLOOR BOX 

    Refer to PROCEDURE - Step 54 , or refer to PROCEDURE - Step 53

  5. INSTALL DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 56 , or refer to PROCEDURE - Step 55

scientia non olet · About LEMON Manuals