Inspection [10/2015 - ]: Procedure
- INSPECT REAR LIGHT ASSEMBLY LH
- Apply auxiliary battery voltage to the rear light assembly LH and check that the lights come on.
OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 2 (B)
Auxiliary battery negative (-) → Terminal 1 (E)Taillight comes on Auxiliary battery positive (+) → Terminal 3 (B)
Auxiliary battery negative (-) → Terminal 1 (E)Back-up light comes on Auxiliary battery positive (+) → Terminal 7 (B)
Auxiliary battery negative (-) → Terminal 1 (E)Stop light comes on Auxiliary battery positive (+) → Terminal 6 (B) and 4 (TRN4)
Auxiliary battery negative (-) → Terminal 1 (E)Turn signal light comes on If the result is not as specified, replace the rear light assembly LH.
*a Component without harness connected
(Rear Light Assembly LH)
- Apply auxiliary battery voltage to the rear light assembly LH and check that the lights come on.
- INSPECT REAR LIGHT ASSEMBLY RH
- Apply auxiliary battery voltage to the rear light assembly RH and check that the lights come on.
OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 2 (B)
Auxiliary battery negative (-) → Terminal 1 (E)Taillight comes on Auxiliary battery positive (+) → Terminal 3 (B)
Auxiliary battery negative (-) → Terminal 1 (E)Back-up light comes on Auxiliary battery positive (+) → Terminal 7 (B)
Auxiliary battery negative (-) → Terminal 1 (E)Stop light comes on Auxiliary battery positive (+) → Terminal 6 (B) and 4 (TRN4)
Auxiliary battery negative (-) → Terminal 1 (E)Turn signal light comes on If the result is not as specified, replace the rear light assembly RH.
*a Component without harness connected
(Rear Light Assembly RH)
- Apply auxiliary battery voltage to the rear light assembly RH and check that the lights come on.