Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly | Front television camera view adjustment | Panoramic view monitor system | Refer to INITIALIZATION [10/2015 - 08/2019]
for Initialization Refer to CALIBRATION [10/2015 - 03/2018] for Calibration |
| Headlight ECU sub-assembly LH |
|
|
Refer to INITIALIZATION [10/2015 - 08/2019] |
NOTE:
If the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.