Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly | Front television camera view adjustment | Panoramic view monitor system | Refer to INITIALIZATION [08/2019 - ]
for Initialization Refer to CALIBRATION [08/2019 - ] for Calibration |
| Front bumper assembly (w/ Intelligent clearance sonar system) |
|
|
Refer to CALIBRATION [08/2019 - ] |
| No. 1 headlight ECU sub-assembly LH |
|
Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] Refer to INITIALIZATION [07/2020 - ] |
NOTE:
If the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.