DTC C1A50: Brake System [08/2016 - ]: Procedure

CHECK DTC OUTPUT

Using the Techstream, check for DTCs according to the prompts on the screen.
Refer to DTC CHECK / CLEAR [08/2016 - ]

HINT:

After turning the power switch from off to on (IG), wait 4 seconds or more before checking for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes
Clear the DTCs according to the screen on the Techstream.
Refer to DTC CHECK / CLEAR [08/2016 - ]

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

Recheck for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

HINT:

DTC C1A50 is stored when a malfunction signal sent from the electronically controlled brake system is detected.
If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1A50 will not be output again.
If DTC C1A50 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 12/2017] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2017 - 03/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2018 - 08/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - 07/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - ]

Result

Result	Proceed to
DTC C1A50 is output	A
DTC C1A50 is not output	B

Result:

Result: