Caution / Notice / Hint
NOTE:
- When using the Techstream with the power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
- When replacing the hybrid vehicle control ECU assembly or ID code box (immobiliser code ECU), refer to Registration.
Refer to REGISTRATION [10/2015 - 08/2019] , or refer to REGISTRATION [08/2019 - 07/2021] , or refer to REGISTRATION [07/2021 - ]
- After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."
HINT:
When DTC B2799-790 and a certification ECU (smart key ECU assembly) DTC are output simultaneously, first perform troubleshooting for the certification ECU (smart key ECU assembly) DTC.