Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear door lock assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	Lane Control System	Refer to INITIALIZATION [08/2019 - ]
		Pre-collision system
		Intelligent Clearance Sonar System*1
		Lighting System (w/ Automatic Headlight Beam Level Control System)	Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ]
		Parking Assist Monitor System	Refer to INITIALIZATION [08/2019 - ]
		Panoramic View Monitor System	Refer to INITIALIZATION [08/2019 - ]
	Initialize back door lock	Power Door Lock Control System	Refer to INITIALIZATION [10/2015 - ]
	Reset back door close position	Power Back Door System (w/ Outside Door Control Switch)	Refer to INITIALIZATION [08/2019 - ]
Rear door glass sub-assembly Rear door glass run	Initialize Power Window Control System	Auto up and down function Jam protection function Key-linked function Wireless transmitter-linked function Key-off operation function Catch protection function Window open warning function	Refer to INITIALIZATION [10/2015 - ]

*1: When performing learning using the Techstream.

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.