Removal [08/2019 - ]: Procedure

1. Remove the 9 clips and cool air intake duct seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 clips.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the 2 clips.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Pull back the edge of the front fender splash shield sub-assembly LH and disengage the 5 claws by pushing the area indicated by the arrow in the illustration with a finger.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Front Fender Splash Shield Sub-assembly LH
   	Place Hand Here
   	Remove in this Direction (1)
   	Remove in this Direction (2)

   NOTE:

   • Do not apply excessive force when pulling back the front fender splash shield sub-assembly LH.
   • To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly LH.
4. Disengage the 2 clips and disconnect the front fender moulding sub-assembly LH.

HINT: 

Use the same procedure as for the LH side.

1. Disconnect each connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A	w/ Panoramic View Monitor System

2. Apply protective tape around the front bumper assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Protective Tape

   HINT: 

   Use the same procedure for the RH side and LH side.

3. Remove each clip.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A	for TMMC Made

   HINT: 

   Use the same procedure for the RH side and LH side.

4. Remove the 8 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

5. Disengage the 4 claws as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Place Hand Here
   	Remove in this Direction

   HINT: 

   Use the same procedure for the RH side and LH side.

6. w/ Intuitive Parking Assist System or Fog Light:
   1. Pull back the side of the front bumper assembly, disconnect each connector.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *A	w/ Intuitive Parking Assist System
      *B	w/ Fog Light
      	Remove in this Direction

      NOTE:

      Do not apply excessive force when pulling back the front bumper assembly.

      HINT: 

      Use the same procedure for the RH side and LH side.

7. w/ Headlight Cleaner System:
   1. Pull back the side of the front bumper assembly and disconnect the headlight cleaner hose.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove in this Direction

   2. Drain the washer fluid.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use a container to collect the washer fluid.

8. Remove the 4 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

9. Remove the 2 clips and front bumper assembly as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction