LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> RX 350 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System (Interior) - Service Information >> Room Light >> Removal [09/2015 - ] >> Procedure

Removal [09/2015 - ]: Procedure

  1. REMOVE SPOT LIGHT ASSEMBLY 
    1. Using the moulding remover D as shown in the illustration, raise the roof headlining assembly until the clip of the spot light assembly can be seen.
      GTY964088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Front
      Move in this Direction
      NOTE:

      Be careful not to damage the roof headlining assembly.

    2. While continuing to hold the moulding remover D, disengage the clip using a screwdriver wrapped with protective tape.
      GTY963403Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape - -
      Front Push in this Direction
      NOTE:

      Be careful not to damage the roof headlining assembly.

    3. Slide the moulding remover D as shown in the illustration and raise the roof headlining assembly until the clip of the spot light assembly can be seen.
      GTY963927Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Front
      Move in this Direction
      NOTE:

      Be careful not to damage the roof headlining assembly.

    4. While continuing to hold the moulding remover D, disengage the clip using a screwdriver wrapped with protective tape.
      GTY963451Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape - -
      Front Push in this Direction
      NOTE:

      Be careful not to damage the roof headlining assembly.

    5. Disengage the 2 guides.
      GTY964377Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Front
    6. Disconnect the connector to remove the spot light assembly.
scientia non olet · About LEMON Manuals