Freeze Frame Data [09/2014 - 11/2017]

FREEZE FRAME DATA
1. Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.

CHECK FREEZE FRAME DATA

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
According to the Techstream display, select a DTC that stored freeze frame data.

Read the freeze frame data recorded when the DTC was stored.

COMBINATION METER

Tester Display	Condition	Displayed Item
B1507	Open in Turn Signal Circuit	Trip Elapsed time after turning the engine switch on (IG)
B1508	Short in Turn Signal / Hazard Flasher Circuit
B150A	Lost Communication with HMI-LAN
B150B*1	Lost Communication with Gigabit Video Interface
B150C	Lost Communication with LIN
U0100	Lost Communication with ECM / PCM "A"
U0129	Lost Communication with Brake System Control Module
U0131	Lost Communication with Power Steering Control Module
U0142	Lost Communication with Body Control Module "B"
U0151	Lost Communication with Restraints Control Module
U0163	Lost Communication with Navigation Control Module
U0182	Lost Communication with Lighting Control Module Front
U023A*2	Lost Communication with Front Camera Module
U1104*3	Lost Communication with Driving Support ECU

*1: w/ Navigation System
*2: w/ Lane Departure Alert System
*3: w/ Pre-collision System

CLEAR FREEZE FRAME DATA
NOTE:
Clearing the DTCs will also clear the freeze frame data.
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Clear DTCs and freeze frame data.
  Refer to DTC CHECK / CLEAR [09/2014 - ]
  
  Body Electrical > Combination Meter > Clear DTCs