Installation [09/2014 - ]: Procedure

INSTALL COMBINATION METER ASSEMBLY
1. Connect each connector.
2. Engage the clamp.
3. Install the combination meter assembly with the 4 screws.
INSTALL METER HOOD SUB-ASSEMBLY
Refer to PROCEDURE - Step 31 [09/2014 - 11/2017] , or refer to PROCEDURE - Step 31 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 31 [10/2018 - 11/2019] , or refer to PROCEDURE - Step 31 [11/2019 - 10/2022] , or refer to PROCEDURE - Step 31 [10/2022 - ]
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 34 [09/2014 - 11/2017] , or refer to PROCEDURE - Step 34 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 34 [10/2018 - 11/2019] , or refer to PROCEDURE - Step 34 [11/2019 - 10/2022] , or refer to PROCEDURE - Step 34 [10/2022 - ]
CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 35 [09/2014 - 11/2017] , or refer to PROCEDURE - Step 35 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 35 [10/2018 - 11/2019] , or refer to PROCEDURE - Step 35 [11/2019 - 10/2022] , or refer to PROCEDURE - Step 35 [10/2022 - ]
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 36 [09/2014 - 11/2017] , or refer to PROCEDURE - Step 36 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 36 [10/2018 - 11/2019] , or refer to PROCEDURE - Step 36 [11/2019 - 10/2022] , or refer to PROCEDURE - Step 36 [10/2022 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [09/2014 - 10/2015] , or refer to INITIALIZATION [10/2015 - 11/2017] , or refer to INITIALIZATION [11/2017 - 10/2018] , or refer to INITIALIZATION [10/2018 - 09/2020] , or refer to INITIALIZATION [09/2020 - 10/2022] , or refer to INITIALIZATION [10/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)
Refer to PROCEDURE - Step 17