Caution / Notice / Hint

NOTE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [10/2014 - 09/2016] , or refer to PRECAUTION [09/2016 - 09/2017] , or refer to PRECAUTION [09/2017 - 05/2019]
When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [10/2014 - 09/2017] , or refer to INITIALIZATION [09/2017 - 05/2019]
After replacing the airbag ECU assembly, refer to initialization.
Refer to INITIALIZATION [10/2014 - 09/2017] , or refer to INITIALIZATION [09/2017 - 05/2019]

HINT:

To perform the simulation method, enter check mode (signal check) with the Techstream (Refer to DIAGNOSIS SYSTEM [10/2014 - ] ), and then wiggle each connector of the airbag system or drive the vehicle on various types of road (Refer to CHECK MODE PROCEDURE [10/2014 - ] ).