Radio Receiver Power Source Circuit [10/2014 - 09/2017]: Procedure

1. Disconnect the radio receiver assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Radio Receiver Assembly)

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I38-12 (GND1) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   I38-17 (+B1) - I38-12 (GND1)	Power switch off	11 to 14 V
   I38-16 (ACC1) - I38-12 (GND1)	Power switch on (ACC)	11 to 14 V
   I38-15 (IG) - I38-12 (GND1)	Power switch on (IG)	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2014 - 09/2016]  , or refer to  PROBLEM SYMPTOMS TABLE [09/2016 - 09/2017] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR