LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> NX 300h >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display System (Service Information) >> HEADUP Display >> Removal [10/2014 - 09/2017] >> Procedure

Removal [10/2014 - 09/2017]: Procedure

  1. DISABLE AUTOAWAY/RETURN FUNCTION 
    1. Disable the autoaway/return function by changing the customize parameter.

      Refer to CUSTOMIZE PARAMETERS [10/2014 - ]

      WARNING:

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      HINT: 

      Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
    3. Turn the power switch off.
  2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2 [10/2014 - 09/2015], or refer to PROCEDURE - Step 2 [09/2015 - 09/2017]

  3. REMOVE REAR DECK FLOOR BOX 

    Refer to PROCEDURE - Step 3 [10/2014 - 09/2015], or refer to PROCEDURE - Step 3 [09/2015 - 09/2017]

  4. REMOVE DECK FLOOR BOX LH 

    Refer to PROCEDURE - Step 4 [10/2014 - 09/2015], or refer to PROCEDURE - Step 4 [09/2015 - 09/2017]

  5. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work.

    Refer to PRECAUTION [10/2014 - 09/2016] , or refer to PRECAUTION [09/2016 - 09/2017]

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [10/2014 - 09/2017]

  7. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to REMOVAL [10/2014 - 09/2017]

  8. REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY 
    1. Remove the 3 screws and No. 1 heater to register duct sub-assembly.
      GTY514060Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE COMBINATION METER MIRROR ECU (HEADUP DISPLAY) 
    1. Disconnect the connector.
      GTY510452Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Connector
      *2 Screw
    2. Remove the 4 screws and combination meter mirror ECU (headup display).
scientia non olet · About LEMON Manuals