LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> NX 300 Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Triple Beam Headlight) - Diagnostic Codes & Symptom Tests >> LIGHTING SYSTEM (For Triple Beam Headlight) >> DTC B2456: Left Headlight ECU Variation Error [10/2014 - 09/2017] >> Procedure

DTC B2456: Left Headlight ECU Variation Error [10/2014 - 09/2017]: Procedure

  1. CLEAR DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

      Body Electrical > HL AutoLeveling > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. CHECK FOR DTC 
    1. Turn the engine switch on (IG).
    2. Check for DTCs.

      Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

      Body Electrical > HL AutoLeveling > Trouble Codes 

      Result

      Proceed to
      DTC B2456 output does not occur
      DTC B2456 output occurs

    Result: 

    DTC B2456 output does not occur 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] 

    Result: 

    DTC B2456 output occurs 

    See step  3

  3. CHECK ECM 
    1. Check that the ECM part number matches the vehicle.

      Result

      Result Proceed to
      ECM part number matches vehicle A
      ECM part number does not match B

    Result: 

    REPLACE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [10/2014 - 09/2017] 

    Result: 

    REPLACE ECM WITH CORRECT ONE. Refer to  REMOVAL [10/2014 - 05/2019]