Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the toe control link removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
| Suspension, tires, etc. | Parking assist ECU initialization | Panoramic view monitor system | Refer to CALIBRATION [10/2023 - ] |
| Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed. | Perform headlight ECU sub-assembly LH initialization | Automatic headlight beam level control system | w/ Front LiDAR Sensor: Refer to REGISTRATION [10/2023 - ] w/o Front LiDAR Sensor: Refer to REGISTRATION [10/2023 - ] |
NOTE:
Be sure to read the "PRECAUTION" thoroughly before servicing.
Refer to PRECAUTION [10/2017 - ]
HINT:
- Use the same procedure for the RH and LH side.
- The following procedure is for the LH side.