Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the toe control link removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Suspension, tires, etc.	Parking assist ECU initialization Adjust steering angle Rear television camera view adjustment (for Rear camera detection system)	Panoramic view monitor system	w/ Advanced Park: - w/o Advanced Park: Refer to CALIBRATION [10/2017 - 11/2021]
w/o Air Suspension System: Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed.	Perform headlight ECU sub-assembly LH initialization	Automatic headlight beam level control system	Refer to REGISTRATION [10/2020 - 10/2023]

NOTE:

Be sure to read the "PRECAUTION" thoroughly before servicing.

Refer to PRECAUTION [10/2017 - ]

HINT:

Use the same procedure for the RH and LH side.
The following procedure is for the LH side.