Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the toe control link removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Suspension, tires, etc.	Parking assist ECU initialization Adjust steering angle Rear television camera view adjustment (for Rear camera detection system)	Panoramic view monitor system	Refer to CALIBRATION [10/2017 - 11/2021]
Suspension, tires, etc.	Rear television camera assembly optical axis (Back camera position setting)	Parking assist monitor system	Refer to CALIBRATION [10/2017 - 10/2020]
w/o Air Suspension System: Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed.	Perform headlight ECU sub-assembly LH initialization	Automatic headlight beam level control system	Refer to REGISTRATION [10/2017 - 10/2020]

NOTE:

Be sure to read the "PRECAUTION" thoroughly before servicing.

Refer to PRECAUTION [10/2017 - ]

HINT:

Use the same procedure for the RH and LH side.
The following procedure is for the LH side.