Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear shock absorber removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
| Suspension, tires, etc. |
|
Panoramic view monitor system | Refer to CALIBRATION [10/2017 - 11/2021] |
| Rear television camera assembly optical axis (Back camera position setting) | Parking assist monitor system | Refer to CALIBRATION [10/2017 - 10/2020] | |
| Rear steering link assembly or rear suspension have been removed/installed, replaced, or adjusted |
|
Steering wheel off-center | Refer to CALIBRATION [10/2017 - 10/2020] |
| Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed. | Perform headlight ECU sub-assembly LH initialization | Automatic headlight beam level control system | Refer to REGISTRATION [10/2017 - 10/2020] |
HINT:
- Use the same procedure for the RH and LH side.
- The following procedure is for the LH side.