Removal [10/2023 - ]: Procedure

HINT: 

Check each part and system if an error is displayed for air movement pattern A.

1. Connect the Techstream to the DLC3 with the power switch off.
2. Turn the power switch on (IG).
3. Turn the Techstream on and enter the following menus: Chassis / Air suspension / Utility / Air Transfer Pattern A.

   Chassis > Air suspension > Utility 

   Tester Display
   Air Transfer Pattern A

4. Perform vehicle height control prohibition and air movement according to the instructions on the Techstream.

HINT: 

Check each part and system if an error is displayed for air movement pattern B.

1. Connect the Techstream to the DLC3 with the power switch off.
2. Turn the power switch on (IG).
3. Turn the Techstream on and enter the following menus: Chassis / Air suspension / Utility / Air Transfer Pattern B.

   Chassis > Air suspension > Utility 

   Tester Display
   Air Transfer Pattern B

4. Perform vehicle height control prohibition and air movement according to the instructions on the Techstream.

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 3

Refer to REMOVAL [10/2023 - ]

1. Remove the bolt and front flexible hose bracket LH from the front shock absorber with coil spring.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the nut and disconnect the front height control sensor sub-assembly LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 7

1. Disconnect the No. 4 height control tube from the front pneumatic cylinder with shock absorber assembly LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Refer to PRECAUTION [10/2017 - ]

1. Remove the front shock absorber cap LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the bolt.
3. Disengage the guide to disconnect the absorber control wire.

4. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

   When reusing the front pneumatic cylinder with shock absorber assembly LH:

   1. Place matchmarks on the front suspension support assembly and pneumatic cylinder chamber.
5. Support the front lower suspension arm assembly LH using a jack and wooden block.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Wooden Block
   *b	Jack

6. Remove the nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

7. Remove the front upper shock absorber bracket plate, and disconnect the front lower shock absorber bracket sub-assembly LH from the front lower suspension arm assembly LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

8. Remove the 3 nuts from the front pneumatic cylinder with shock absorber assembly LH (upper side).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

9. Slowly lower the jack and remove the front pneumatic cylinder with shock absorber assembly LH.
10. Remove the nut.

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

11. When reusing the front pneumatic cylinder with shock absorber assembly LH:
    1. Remove the No. 2 connector, plate and 2 O-rings.

       Refer to PRECAUTION [10/2017 - ]

1. Secure the front lower shock absorber bracket sub-assembly LH between aluminum plates in a vise.
   NOTE:

   Do not overtighten the vise.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the bolt and front lower shock absorber bracket sub-assembly LH from the front shock absorber assembly.