Removal [10/2017 - 10/2020]: Procedure

1. Remove the 3 nuts and No. 2 differential support protector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Use the same procedure described for the No. 2 differential support protector.

1. Remove the 2 bolts and rear suspension member brace LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Use the same procedure as for the LH side.

Refer to REMOVAL [10/2017 - 10/2020]

HINT: 

Use the same procedure as for the LH side.

1. Using SST, remove the rear drive shaft assembly LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09520-01010 
   • SST: 09520-24010 
     1. 09520-32040
   NOTE:

   • Do not damage the oil seal, boot and dust cover.
   • Do not drop the rear drive shaft assembly LH.
   • When carrying the rear drive shaft assembly LH, hold it horizontally.

   HINT: 

   Hook the SST claw at the position shown in the illustration to remove the rear drive shaft assembly LH.

2. Using a screwdriver, remove the shaft snap ring.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Do not damage the spline of the rear drive shaft assembly LH.

HINT: 

Use the same procedure as for the LH side.