Removal [10/2017 - 10/2020]: Procedure

DISCONNECT BRAKE BOOSTER PUMP CONNECTOR
Refer to PROCEDURE - Step 3 [10/2017 - 09/2018] , or refer to PROCEDURE - Step 3 [09/2018 - 10/2020]
REMOVE FRONT WHEEL
Refer to REMOVAL [10/2017 - 10/2023]
DRAIN BRAKE FLUID
NOTE:
If brake fluid leaks onto any painted surface, immediately wash it off.
REMOVE FRONT PAD WEAR INDICATOR WIRE ASSEMBLY RH (for RH Side)
Refer to PROCEDURE - Step 3 [10/2017 - 09/2019] , or refer to PROCEDURE - Step 3 [09/2019 - 10/2020]

DISCONNECT FRONT FLEXIBLE HOSE

Remove the union bolt and gasket, and disconnect the front flexible hose from the disc brake cylinder assembly LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

Remove the 2 bolts and disc brake cylinder assembly LH from the steering knuckle.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE FRONT DISC LH

Put matchmarks on the front disc LH and the front axle hub sub-assembly LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Matchmark

HINT:

Not required when replacing the front disc LH.

REMOVE FRONT DISC BRAKE PAD

Remove the front disc brake pad from the disc brake cylinder assembly LH.

REMOVE PAD WEAR INDICATOR WIRE CLIP (for RH Side)
Refer to PROCEDURE - Step 6 [10/2017 - 09/2019] , or refer to PROCEDURE - Step 6 [09/2019 - 10/2020]
REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM
Refer to PROCEDURE - Step 7 [10/2017 - 09/2019] , or refer to PROCEDURE - Step 7 [09/2019 - 10/2020]