Removal [10/2017 - 09/2018]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Protective Tape

   Put protective tape around the lower windshield outside moulding LH.

2. Detach the claw as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

3. Using a screwdriver, detach the claw and remove the lower windshield outside moulding LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

   HINT: 

   Tape the screwdriver tip before use.

HINT: 

Perform the following procedure only when replacement of a No. 1 windshield outside moulding clip is necessary.

1. Detach the claw as shown in the illustration to remove the 5 No. 1 windshield outside moulding clips.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

HINT: 

Perform the following procedure only when replacement of a No. 3 windshield outside moulding clip is necessary.

1. Remove the windshield glass sub-assembly.

   Refer to REMOVAL [10/2017 - 09/2018]

2. Insert a 4.0 mm (0.157 in.) drill bit into a drill.
3. Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

   Standard Measurement

   Area	Measurement
   A	5.0 mm (0.197 in.)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Tape

   NOTE:

   Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

4. Lightly press the drill against the No. 3 windshield outside moulding clips to drill off the No. 3 windshield outside moulding clip flanges, and remove the 5 No. 3 windshield outside moulding clips.
   WARNING:

   Be careful of the drilled No. 3 windshield outside moulding clips, as they may be hot.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Flange

   NOTE:

   • Pressing the drill too firmly will cause the No. 3 windshield outside moulding clip to turn and result in the No. 3 windshield outside moulding clip not being drilled through.
   • Prying the No. 3 windshield outside moulding clips with the drill may damage the No. 3 windshield outside moulding clip installation holes or drill bit.
5. Using a vacuum cleaner, remove the No. 3 windshield outside moulding clip fragments and shavings from the drilled areas.