Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the windshield glass removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
for Stereo Camera Type: Windshield glass (Removal and installation)	Adjust object recognition camera	Dynamic radar cruise control system (for Stereo camera type) Front camera system (for Stereo camera type) Lane control system (for Stereo camera type) Road sign assist system (for Stereo camera type) Pre-collision system (for Stereo camera type) Automatic high beam system	Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [10/2017 - 10/2020]
for Mono Camera Type: Windshield glass (Removal and installation)	Adjust forward recognition camera	Forward recognition camera system (for Mono camera type) Dynamic radar cruise control system (for Mono camera type) Lane-keeping assist system (for Mono camera type) Pre-collision system (for Mono camera type) Automatic high beam system	Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [10/2017 - 09/2018]

HINT:

Use the same procedure for the RH and LH side.
The following procedure is for the LH side.