Removal [12/2017 - 10/2020]: Procedure

Refer to PROCEDURE - Step 4

Refer to REMOVAL [12/2017 - ]

1. Remove the 2 bolts and crankshaft pulley cover.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 bolts and crankshaft damper sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST to hold the crankshaft pulley, loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hold
   	Turn

   • SST: 09213-54015 
     1. 09213-70020
   • SST: 09330-00021 
2. Using SST and the crankshaft pulley set bolt, remove the crankshaft pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hold
   	Turn

   • SST: 09950-50013 
     1. 09951-05010
     2. 09952-05010
     3. 09953-05010
     4. 09954-05021

   HINT: 

   Apply lubricant to the threads and end of SST.

1. Using a screwdriver with its tip taped, pry out the timing chain case oil seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protective Tape

   NOTE:

   After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.