Installation [10/2020 - ]: Procedure

1. Apply MP grease to the lip of a new timing chain case oil seal.
   NOTE:

   • Do not allow foreign matter to contact the lip of the timing chain case oil seal.
   • Do not allow MP grease to contact the dust seal.
2. Install the timing gear case or the timing chain case oil seal to SST.
3. Set SST and the crankshaft pulley set bolt as shown in the illustration.

   HINT: 

   Make sure to leave the crankshaft pulley set bolt screwed into the crankshaft by 2 or 3 threads.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Crankshaft Pulley Set Bolt
   *2	Timing Chain or Belt Cover Sub-assembly
   *3	Timing Chain Case Oil Seal
   *a	Oil Seal Protrusion Height

4. Using SST and the crankshaft pulley set bolt, evenly tap in the timing chain case oil seal until its surface is flush with the end face of the timing chain or belt cover sub-assembly.
   • SST: 09223-51010 

   Oil Seal Protrusion Height

   0 to 0.5 mm (0 to 0.0197 in.)

   NOTE:

   • Do not tap the timing chain case oil seal at an angle.
   • Keep the lip free of foreign matter.

1. Align the crankshaft timing gear key with the key groove of the crankshaft pulley, and slide on the crankshaft pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hold
   	Turn

2. Step 1:
   1. Using SST, tighten the crankshaft pulley set bolt.
      • SST: 09213-54015 
        1. 09213-70020
      • SST: 09330-00021 

      Torque: 120 N*m (1224 kgf*cm, 89 ft.*lbf) 

3. Step 2:
   1. Tighten the crankshaft pulley set bolt.

      Torque: 365 N*m (3722 kgf*cm, 269 ft.*lbf) 

1. Install the crankshaft damper sub-assembly with the 2 bolts.

   Torque: 24 N*m (245 kgf*cm, 18 ft.*lbf) 

   Bolt Length

   Item	Length
   Bolt	20 mm (0.787 in.)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to INSTALLATION [12/2017 - ]

Refer to PROCEDURE - Step 13 [12/2017 - 11/2021] , or refer to PROCEDURE - Step 13 [11/2021 - ]

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 15 [12/2017 - 11/2021] , or refer to PROCEDURE - Step 15 [11/2021 - ]